this should work right, or did the syntax change: · Entire

Introduction

This should work right, or did the syntax change:

❯ go run ./cmd/git-sync sync

Flags:

• --protocol v2
• --measure-memory
• -v
• --target-username git
• --target-insecure-skip-tls-verify
• --tags

Example URLs:

• Kubernetes Repo
• Local Target

Error Message

error: list target refs: pkt-line 1: cannot read hash, pkt-line too short (# service=git-receive-pack)
exit status 1

Debugging Steps

1. Checking the current CLI and sync path in this repo.
2. Tracing the origin of the git-receive-pack pkt-line error to determine if it's due to syntax or protocol behavior.
3. Confirming that flags are still valid and checking for target ref discovery issues.

Additional Details

• The target is always queried via v1 receive-pack discovery regardless of --protocol v2 applied to the source side.
• Issue may stem from unexpected info/refs?service=git-receive-pack responses.
• Valid command syntax confirmed; however, further checks needed on the target endpoint handling.

Notes on Workflows

• It's important to ensure that the target URL points to a valid Git smart-HTTP endpoint.
• Likewise, checking that authentication for the target repo is configured properly is crucial.

Candidate Changes to Investigate

1. Target Discovery: Inspect changes in the target discovery mechanism following codebase rewrites.
2. Decoder Logic: Ensure the decoding logic is robust against empty or unexpected advertisement shapes.

Conclusion

If issues persist regarding the target receive-pack advertisement, logging improvements should be implemented to show the first bytes of any malformed response to expedite debugging.